Amana DLW330RA Top Load Washer "replacing idler pulley" Questions

...idler pulley in the picture is behind the motor. I would check the ilder pulley to see if it rotates freely and does not have any odd side to side movements. If it does then replace the idler pulley ...

...replacing belts like this! A few things to check. Make sure that the idler pulley is turning freely without any signs of distress from the bearings. Make sure that when the belt is installed that all ...

...panel off of the dryer. place the idler pulley in the holes located below the motor pulley put the belt around the drum pull the idler back and the belt loops around the idler and onto the motor ...

left side of black plastic idler pulley. Work belt around transmission pulley. You can press on opposite end of idler pulley arm to loosen belt tension. Make sure belt is on all pulleys before testing

...you are replacing the belt. The small idler pulley can be worked on by running the belt on the big pulley when reinstalling the motor Try not to stretch the spring for the idler pulley, hope this ...

...idler pulley if necessary. Bearing - A worn bearing in the tub can cause a squealing noise. Replacing the bearing will typically require disassembling the washer. Drive motor - If the drive motor is ...

idler arm, start belt on large tub pulley, turn tub pulley by hand to run belt on, release tension on idler arm. Replace front panel and lower top. Hope this helps... Please post back if you need more

...idler pulley) is not missing a chunk of plastic and it spins free when flung with your finger i would say its ok, also you can check the spring on idler pulley by pushing it in and as long as it ...

...idler pulley is fine. the belt should measure 93 3/8' but it measures 95'. the belt simply goes around the drum, idler pulley, and motor shaft right? Hi, Yes, your right about the 93 3/8 length.... ...

...idler pulley to left to release drum belt tension. Remove the belt from the motor pulley. 3. Remove the drum and belt from the cabinet. 1-- Prepare for replacing the dryer belt by lifting the ...