Procom 10K BTU, Vent Free, 2 Plaque Infrared Space Heater, Natural Gas Infra-Red Patio "gas heaters wont light" Questions

...gas heater. Pilot light wont stay lit snd heater flame wont stay lit. Are you holding down the pilot light button long enough for the heat sensor probe to get hot and turn on the gas valve? It takes ...

...gas heater. What's wrong with my heater? My mr heater wont stay light unless its above 3. It only stays on about 5 min then pilot goes out. It is gas heater. What's wrong with my heater? Theres a ...

...wont light Is it Propane check pilot light and if youhave gas make sure that you do notlight a flflame or cigerette if gas has been on without pilot light lit make sureto tthen gas line off clear ...

wall heater burners wont ignite We have an Empire gas wall heater. I can light the pilot, but the burners don't ignite. Don't the burners light almost at once? you may have a bad gas valve

...wont lite up, but pilot light does The ignitor works and the pilot light goes on, but when I turn the knob to get the gas going the heater doesn't lite. It doesn't sound like gas is going through. ...

...wont' light. There is no gas going through the control value. I disconnect the thermocouples and blown air through the valve and they are clear, when I reinstall the thermocouple to the valve, no air ...

...gas heater model 3e469 wont stay lit chech the flame sensor or thermocouple which ever it is equipt with. Sensors can be cleaned by lightly sanding them and therocoulpe's need to be

...gas water heater is still working if the pilot lights when held but wont stay lit, the thermocouple is shot, local hardware stores sell universal thermocouples. self explanatory to replace. if even ...

...gas heater the yellow light turns off the red light stays on heater wont kick on m1m series I am guessing the thermostat is broken. If you are going to try and fix it, be careful. I would suggest ...

my big buddy heater has sat all year and now it wont light you may have cobwebs in the gas orifices. shut off gas and power then poke each hole out with a wire turn on gas and power and try again