Question about Maytag Washing Machines
agitator back on , and I tighten the bolt but it keeps falling off. Also, during the spin cycle it make a knocking noise. I tried redistributing the load, but it doesn't help. there should be a rubber
bolt) i place the agitator on the floor, step on either side of it and pull up on the top half, ittl come loose, needs a little help! a word of advice though is after replacing the agitator dogs, turn
that holds the agatator on has come loose and is properly floating around in the agitator.Or it just needs to be pushed down to lock it in place. At worst the bolt and nut has rusted away. (repair man
agitator bolt keeps coming loose The agitator is in 2 pieces, the top piece is bolted to the bottom piece after mating top and bottom spline sections together. This bolt keeps coming loose and the top
Question about Whirlpool Cabrio Washing Machines
...bolt part way. Pull up on the agitator by both sides of the rim, then finish removing the bolt after the device is loose. (Keeps you from smacking your face when the agitator comes loose.) Hope this ...
...this normal?? There is a bolt that holds this together that screws into shaft. Is the upper agitator broke? Or the ratcheting part in the center? Give full model number to further assist
agitator maytag top load washer the agitaor is loose it want stay locked down it keeps coming up during wash cycle is there a clip that holds it down there should be a 7/16s bolt under the cap try ...
...bolt of the agitator. You will have either a 7/16? hex bolt or a recessed square plastic nut. If you have the square recessed type, use a 3/8? to ½? ratchet adapter to remove. Carefully remove the ...
...bolt or a new agitator ???? Hi just read your posting.1st thing to do is to undo the screw holding the agitator to the shaft and lift the agitator out.Then purchase some Loctite thread lock from you ...
3,787 questions posted
Usually answered in minutes!
57 Questions
48 Questions
24 Questions
12 Questions