Dayton Gas Furnace Heater "vent switch tripped" Questions

Ad

...chamber opens when heat is running If the rollout switch is tripping that usually means that the venting is either not working or is insufficient to get the combustion gases away properly. Check ...

Ad

Question about Goodman Heating & Cooling

1 Answer

...vent pipe may be inadequate, that is why the roll out switch that you by-passed tripped. If you replace the switch that was by-passed I bet the over flaming stops,as the gas will quit overflowing. ...

Ad

Question about Heating & Cooling

1 Answer

vent switch was tripping out off&on and would always restart after reseting it but now nothing make sure there is nothing blocking the vent, then check switch for continuity with a ohms meter,Good

Question about Heating & Cooling

2 Answers

...vent safety switch Williams wall furnace model 3509622 the reset is at the top left side of the furnace. take the cover off n press the red button. the switch could be failing but CHECK drafting ...

Question about Cozy Heating & Cooling

1 Answer

...vent , the switch is set at 350 degrees it detects back draft do to a improper vent or blockage of vent, if the installer use the old vent system that is more than likley the problem, have the ...

Question about Cozy Heating & Cooling

1 Answer

...vent switch, I reset it and it started up again. The switch is rated at 350 degrees and I took a temperature reading after letting it run for 15 min and only came up w/ 135 degrees. So something is ...

...forced air vent motor has to be running,closeing switch,if vent is blocked or restricted,gas valve wont come on.most furnaces also have self diagnostics look in little windows for blinking

...switch trips in both levels of heat operation. Will operate in ''Emergency run'' mode. ( Full Heat ) Sounds like you have a vent issue. The fact that it does not matter what stage of heat you are in ...

Question about Dayton Heating & Cooling

1 Answer

switch tripped. The owner and I believe that the unit may need an inducer fan on the exaust vent pipe. What do you think. Signed Orlando Hutchinson email : [email protected] yeah...it may be needing

Question about Cozy Heating & Cooling

1 Answer

If the draft is not pulling air toward the vent system, the heat from the cooling heater will trigger the safety switch and shut off the pilot. You may have to raise the vent pipe to establish a draft

Not finding what you are looking for?
Dayton Gas Furnace Heater Logo

361 questions posted

Ask a Question

Usually answered in minutes!

Top Dayton Heating & Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Dayton Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...