Dayton Gas Furnace Heater "furnaces venting" Questions

Ad

Question about Goodman Heating & Cooling

1 Answer

heat not coming on carrier gas pack code 31 24volts o.k. no lighting condition code 31 indicates pressure switch did not close or reopened during the heat cycle....1st thing to check is the inducer ...

Ad

...furnaces can use PVC pipe for venting and the also come equipped with a condensation pump, which yours doesn't. For more information on your furnace and how it's to be safely installed and vented, ...

Ad

janitrol furnace-circuit board code giving 3 blinks vent pressure switch or vent blockage where do i check on system / furnace was running fine up to this point /turned it off for about 1hr. and when ...

Question about Heating & Cooling

2 Answers

My heat won't blow through the vents. The furnace ignites itself but it cuts off after a minute. I've sanded the flame sensor but it still won't work. What can I do now? I just want heat in this ...

Question about Goodman Heating & Cooling

1 Answer

goodman furnace wont come on turn on powervent works nothen else happens.I change the power vent motor last year seems like not getting to next stage code says presure switch failure to close and to ...

Question about Heating & Cooling

2 Answers

How to reset vent safety switch Williams wall furnace model 3509622 the reset is at the top left side of the furnace. take the cover off n press the red button. the switch could be failing but CHECK ...

I have a keeprite furnace that is acting up the furnace starts up and runs some times for minutes and sometimes seconds the pressure switch is cutting in and out but it doesn't seem to have a steady ...

model #m3uf0245a keeps flashing open roll out reset will run for about two hours then trips out again. Hi, The furnace is not venting properly which can be very dangerous...check the vent pipe or the ...

i have a category IV furnace. make up air venting?? i have a category IV furnace. I am using a 2 pipe venting system. building inspector says i need a make up air vent. he won't give me a specific ...

Question about Dayton Heating & Cooling

1 Answer

I found my furnace not hot enough, and then replaced with a new Lexnnox,, however, I am still feel the air is weak and not hot, just little bit warm, I went to my friendâ??s home, his van is ...

Not finding what you are looking for?
Dayton Gas Furnace Heater Logo

361 questions posted

Ask a Question

Usually answered in minutes!

Top Dayton Heating & Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Dayton Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...