Pioneer TS-W307D4 Car Subwoofer "mono amp sets terminals" Questions

...amp in mono @ 4ohms. To do this, run from one voice coil to another, a jumper. connect positive from one voice coil to the neg of the other voice coil. Then connect the remaning positive on one voice ...

...mono subwoofer amp but i have 2 sets of wire terminals and they go negative negative postive postive. Which do I use? Depends if its bridgeagle or bridge internally. bridgeing provides the most power ...

...amp. Which ones do I use ?. if your amplifier is 2 ohm mono stable - you can wire them in parallel. Put a piece of wire from one + terminal to the other + terminal on the subwoofer. Then do the same ...

...amp is mono run the wires to the first terminal and then from there to the second set of terminals. PLEASE NOTE that by doing that you are bridging the speaker if the speaker was 4ohms to start with ...

...on the outside with just one wire. This is all assuming that you are hooking up only one sub. If you attempt to hook up 2 subs like this to a mono amp, you will drop the load to 1 ohm. hope this ...

...how do i hook it up to a plnet audio 900.1 mono If it has only one set of terminals on the sub just plug and play- if it has dual coils wire them in parallel(+ to+ and - to -) and wire them to the ...

mono load. Connect both + on the sub to the + on the amp. Connect both - on the sub to the - on the amp. Many professionals simply jumper the 2 + and 2- on the sub.... then run 1 set of wires from one

amp is designed to run 500 watts bridged mono into a 4 ohm load. Lets also say that your subs have dual 4 ohm coils on them. To achieve the 4 ohm load you would want to run the coils in series on each

...amp is no lower than 2 ohms stable mono. the proper way to wire this so that you do not burn out the amp is to run the 2 vioce coils in series. run the positive lead from the amp into the positive ...

...amp thats mono block with 1 channel but two positives and two negatives what is the best way to hook it up for two 12in. The fact that there are 2 output terminal sets are simply for convenience. You ...