Technics SL-BD22 Turntable "put drive belt" Questions

drive belt on my Technics SL-BD22 has come completely off, how can I put it back on? Ok.Thats a difficult part to explain on a pick up.So listen up and give attention.Take off the plate of your driver

...drive rim. F) Put the record mat back on the platter. G) While holding the tone arm in its rest position, slowly turn the platter by hand clockwise at least 10 rotations to clear the mechanism?s ...

...drive belts is easy, fitting them is the problem. If it is still attached in any way make a note or a photo of how it is fixed. This will help to putting a new one on. Measure the diameter of the old ...

...in the platter, put the belt around the motor drive shaft. Rotate the platter a couple of revolutions to make sure everything's seated properly and you should be back to spinnin' the hits in no

drive belt on my Sony PSLX250H turntable came off. I don't know how to route it to put it back in plade Usually, for most turntables, the belt goes on the bottom of the platter first. Then you put the

...drive belt came off i do not know how to put it back on please help! I have a Denon - Fully Automatic Turntable System - DP-29F It doesn't give me much help in the instructions on how to put it back ...

...drive pully's, and the belt. You should be able to put the belt back on the platter pully and then around the motor pully and the just align the platter back up with the spindle and gently lower it ...

...put this belt on so I can start listening to my albums again. Thanks Terry Terry, Remove the rubber mat from top of platter. This will expose two slots in the aluminum platter. Lift aluminum platter ...

...the belt around the table inner bottom ring holding a little of the belt with a finger stretch it a little and put it around the drive motor and drop the bable onto the spindle and you are ...

...Drive Turntable Vinyl Engine How to set it up after you put the belt on. How to set up Turntable cartridge alignment overhang VTA VTF vibration... Another look on how to change a belt on a turntable? ...