low flame signal when the heater kicks on the flame only last seconds then it turns off by its self then it returns on and off and continues to do so until it finally stays on this is not normal and ...
Question about Williams Heating & Cooling
...low flame will not stay on high flame My Charmglow heater lites just fine then the flame goes to low and will not stay on high flame. I cannot adjust the flame up or down. Pilot sensor or ...
low flame signal, what is a flame sencor and where is it at? The flame sensor is located on the burner itself inserted into the flame it is sometimes called flame rod about 2 inches long and about the
...low flame yellow lite flashes 3 times Not getting enough heat The system most likely just needs to be cleaned thouroghly. The burners, orifices, ignition assembly and flame sensors get diry, rusty, ...
low flame signal my goodman heater struggles to turn on and 7 flashing lights come witch indicate low flame signal,what does this mean and how do i fix it? There is a small probe that is located ...
...low flame Empire DV-35 all works as it should - BUT has low heat. Main burner flame seems low. Could there be an issue with gas valve - not opening enough to allow full gas to main burner. Themopile ...
...combustion so you get the yellow tinging Vulcan oil heaters (Australia) will burn best with blue base flame and dancing yellow tips when on high, on low it will be a small soft blue and yellow ...
Question about Heating & Cooling
...flame is too small and doesn't cover the thermocouple, it may be adjusted too low, or you have low gas pressure or you have a leak in your gas line coming in to the heater. If the flame looks like a ...
low flame, replaced regulator, used different propane tanks and still flame is very low. The orifice is clogged. It should unscrew and get a fine piece of wire (.050") and you may see some debris come
Question about Heating & Cooling
...flame is established. This is a very low amperage, as low as 4 MICRO-amps and can only be read with a Micro-ammeter. Many times, if the problem persists after the flame rod has been replaced, it is ...
52 questions posted
Usually answered in minutes!
46 Questions
18 Questions
7 Questions
5 Questions
3 Questions