GE Profile WPRE6100G Top Load Washer "not turn" Questions

...not turn. This occurs in all cycles. The basket will fill properly. At selected level, motor activates, hums and does not even slightly turn. Basket can be turned, and pulley below turns, but motor ...

Amana Softsound II dish washer model DWA33a impeller is not turning. R9800133 Cover, Volute is removed. Nothing blocking it from turning. The motor is turning because not only is it humming -- the ...

...not turn the belt was off but now put it back on still not turning altho motor at bottom is if the motor is running, the belt is on but the drum is not turning then either the belt is slack and ...

...not turn My washer drum will not turn to spin the water out. The agitater will turn and the water will drain but the drum itself will not turn in order to spin out the excess water. check the belt if ...

not turn off. Washer will not turn off water unless we turn the dial manually? We have tried all settings and still not operating in the Automatic position. We always have to manual turn to stop water

not turning and no heat My admiral dryer timer won't turn even though dryer drum is turning also there is no heat. It could be the high temp fuse on the element and the timer not turning depends doyou

...not turn over, when machine is accessed from the back the tumble action attemps but does not complete. Whene helped it will tumble. It acts as though the motor has lost power enough to tune the tub. ...

...not turn by hand If it has a belt try loosening the belt and see if the transmission and pump will turn and are not stuck. If they are they will have to be replaced. Try the motor and see if it turns ...

drum does not turn. If you can hear the motor turn on, but the drum does not turn, it's probably a broken belt. If you CAN'T hear the motor turn on, it could be the timer, the motor or safety controls

...not turn Hi, There can be many reasons why your dryer will not start or turn... The most common causes are the belt breaking or jumping off, or the motor goingbad... Here are a couple of tips that I ...