GE Profile WPRE6100G Top Load Washer "metal shavings washing machine" Questions

plastic shavings and metal bits in drum and filter after washing is complete rang washing machine repair man

...metal shavings under motor makes lound noise when in spinning cycle. I took off front cover to look at the motor, thier is a pin or clamp that had spen off, I had tightend it and put it back on, it ...

shavings on my wet clothes in a Bosch Nexxt 500 plus washer. It could be that the basket is loose. If you hear a loud noise like metal to metal you have a loose bearing causing the basket to shake and

...metal shavings on the floor and it looks like the metal (inner?) drum is not quite centered. Any clues? Does this happen a lot? It is only 3 year old. its most likely bad bearings and basket. usually ...

metal shavings..have not used since but repairman whom thought it was the shocks has not been able to make it out. What would metal shavings mean? The rear half of the outer tub that contains the rear

...metal shavings was under the clutch. so i know what the problem is. What i need to know is should i replace both the clutch and the motor? due to wear on the shaft? or can i just replace the clutch? ...

...are level in it. It only does this at the very end of the spin cycles. Any idea to what it is and how we can fix it ourselves? check your drive block under your agitator if metal shavings ...

...metal shavings Possible Drum barrings failure. Drum unseated making contact with Housing. switch off. turn drum by hand check it is free of obstruction. Not a job I would recommend for a DIY ...

...Then check the holes in the drum itself to see if there is any protruding metal shavings that is causing the problem. There should be no rough edges at all. It sounds like the drum is the

noise during agitation. There are metal shavings under motor. I can lift up basket and it stops rubbing bottom of frame. How can I raise tub to prevent grinding against bottom of machine? What make ??