Technics SL-1210 Turntable "anti skate" Questions

...is gone and therefore the needle isn't holding to the grooves rather than a tracking weight or anti skate problem. [email protected] hi, take a WD40 spray it gently on the part of the

...anti - skate and tone arm hight on my turntables what are the proper specs, thanks. Anti skate should be set the same as the weight, i.e 3 gram of weight = 3 on the anti skate. ...

an odd record then skips a few grooves on a good condition record, you can adjust the Anti skate control to prevent it. Adjustment it is like setting the stylus pressure, a question of trial and error

...anti skate setting at the back of the turn table, a round adjustable bit with numbers, increase the anti skate and then use the balance weigth (weight right at the back of the arm that turns to get ...

...anti skate spring is busted I think? Need somewhere in Australia, preferably brisbane. The anti skate spring is not part of the arm assy but can be obtained separatly. ...

record; doesn't engage grooves stylus "skates" across record when turntable is turned on (new at-lp2D-usb turntable, just assembled). Increase the weight of the arm, check if it has anti-skate control

skip repeats halfway through Sounds like to much anti-skating with an old stylus. That can pull a needle back over and over again around the center of the record. Try setting the anti-skating at 0% ...

...rotate the platter ClockWise a few turns to disengage any cueing mechanisms. Set the Tracking and Anti-skating controls to 0. Disengage the tonearm elevation control. The tonearm will either float ...

Anti skate knob broke off, will glue help? It all depends on which bit of it broke off. If it is just a cosmetic damage and doesn't effect the actions of it, then go ahead a glue it. However if it ...

anti-skate adjustment. Set the antiskate adjustment to the same number as the needle pressure setting (i.e. 2.5 grams would be an anti-skate setting of 2.5). If you are back cueing or scratching, then