Mitsubishi WD-57732 Projection Television "need lamp housing replace bulb" Questions

Ad

Question about Mitsubishi WD Televison & Video

1 Answer

...lamp is out and I need another bulb ...? If I am correct, are there instructions on how to replace the bulb? remove front panel under screen, rove screws from lamp access panel cover. then remove the ...

Ad

Question about Mitsubishi WD Televison & Video

1 Answer

need to remove the old lamp from the housing and transfer the lamp connector to the new lamp. You should use either gloves for this procedure or at a minimum use a paper towel to handle the lamp. WASH

Ad

Question about Mitsubishi WD Televison & Video

1 Answer

...it,you could have the plug upside down or you need to visually see if the ballast plug is damaged.you may need to replace the ballast if you still are getting a red lamp error on the front of the

Question about Mitsubishi WD Televison & Video

1 Answer

...LAMP STAUS LIGHT NEED TO REPLACE IT HOW MANY SCREWS IN BACK DO I NEED TO REMOVE TO GET TO LAMP AND APPROXIMATELY HOW LONG SHOULD PUTTING NEW LMP IN TAKE AND DO U HAVE ANY VIDEOS TO SHOW ME You must ...

...housing assembly be better? I have seen the youtube DIY videos and doesn't look to hard either way. I just wanted to know your advise to your common person when replacing. just replace the lamp, no ...

Question about Mitsubishi WD Televison & Video

1 Answer

...need a new lamp for your TV. you can get it on Amazon. Here what you need to look for if you want to do it on the cheap. Tv lamp 915p061010. They usually run between 80 to 120. With the house. Around ...

Question about Mitsubishi WD Televison & Video

1 Answer

...need a new projection lamp. The "strange sound" you hear is most likely the lamp trying to fire.After awhile, the set"gives up' and shuts down. There is a small door in the rear, and the lamp is ...

Question about Mitsubishi WD Televison & Video

2 Answers

...lamp and still have problems, you need to try replacing a couple of cpas on the power supply board. They are C9A37 and C9A38, 3300 ufd. at 16 volts. I would use 3300 ufd at 25 or 35 volt caps for ...

the lamp compartment didnt get pushed back inside the set. If they are still there secure inside the lamp compartment then you will need a new ballast which you can get from www.tvrepairworld.com 

Question about Mitsubishi WD Televison & Video

1 Answer

need a new bulb. It is a DLP lamp, part number 915P020010. You can buy just the bulb for $130 at dlplampexpress.com or the entire housing unit with the bulb already installed for about $368 on Amazon.

Not finding what you are looking for?
Mitsubishi WD-57732 Projection Television Logo

81 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1259 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...