Question about Cross Office Equipment & Supplies
...wont turn on? please help If you did not turn unit off right away after it jammed it is possible that you may have burned out the motor. Remove the paper jam and see what happens. my motor is fine, ...
wont do anything do you mean that the motor dosnt run??? or that it runs but dosn't shred paper.??? In either case you have either broken gears or defective pcb related components...contact Royal at 1
Question about Staples Office Equipment & Supplies
staples xpl 200d shredder turns on and runs, but teeth are seized up, running in reverse wont fix it Paper is jammed in teeth. Have not had any problems with it and have used the lubricating teeth ...
Question about Shredder Office Equipment & Supplies
...turn the shredder over (after unplugging the power cord) and see if you can pull the pieces out from under side. Sometimes the motor gear teeth break off, and the motor just spins but wont go forward ...
...wont run.. Paper jammed in head and cannot remove it--no reverse or forward will work. This is the most common problem..."too much paper". If it won't go in either direction the only option is to ...
wont shred papers. Seldom used, oiled, never overheated. Blue ready light on. Will run in reverse not in forward. Will not shred. The unit makes a short buzz and stops. I disassembled, cleaned sensors
...wont shedded The cutter won't turn in either reverse of forward. there is power and a low humming noise when the paper is entered into the machine. I have cleared and paper jams and tried turning or ...
Question about Royal Office Equipment & Supplies
...wont go back or forward then your only recourse is to open it up and "manually" attempt to turn the motor and/or gears untill you can clear the paper. Dont put so much in at a time; and make sure you ...
wont spin at all, why is it doing this? most likely you have broken one of the gears on the side of you shredder motor. If the motor spins look and see which gears are turning...... then you'll notice
Question about Fellowes Manufacturing Office Equipment & Supplies
...sensor light lights up. Power is good, since the sensor light turns on when you touch the entry point. However the motor wont turn the blades or even seemingly power them up. plastic gears for ...
5 questions posted
Usually answered in minutes!
14 Questions
22 Questions
3 Questions