Question about Frymaster Dean Kitchen Appliances - Others
clean the entire pilot assembly and the gas line going to the orifice. Many times when a pilot tube has leaked and possibly burned incorrectly, the gas line can fill up with suit. Your clogged orifice
Question about Pitco Frialator Kitchen Appliances - Others
...CLEAN AND NEW THERMO COUPLING FITTED DONT KNOW WHAT TO DO NEXT This is caused by a pressure problem. There should be an adjustment screw on the gas valve regulator. Also, make sure the pilot orifice ...
Question about Frymaster Dean Kitchen Appliances - Others
...Then remove the gas tubing from the pilot assembly. inside of the pilot is a orifice. Looks like a tiny thimble. Remove it and clean the hole in the orifice. (Very Small hole) Reassemble and
Question about Imperial Kitchen Appliances - Others
...clean the pilot area where the gas comes in. Make sure your gas line is not crimped. If you are handy, you may can take apart the orifice itself and clean it. Usually, I would say replace the ...
...gas valve one at a time, and clean the contacts with a food grade electronics contact cleaner and degreaser. Make sure all wiring is tight, not loose fitting, and clean. The thermo coupler, or ...
Question about Pitco Frialator Kitchen Appliances - Others
...like a little thimble. Remove it and clean it. the gas flows through a very small hole that clogs very easy. Reassmble it tighten the gas line. Check for leaks with some bubbles and give it a
...clean out your gas lines? Sometimes, especially in LP fryers, they get stuff up inside the gas lines, which have to be cleaned out in order for them to work correctly...I sure sounds like a gas ...
Question about Pitco Frialator Kitchen Appliances - Others
...this done by a pro. you have to remove the gas valve and control plate to get the burners on the right. use a brush to clean out the the tubes. Then you will get that classic SG14 roar when she
...that has six burners. They all light and stay on for about 10 seconds and then they go out. I cleaned the spark ignitor and cleaned the gas valve connection. Do you have any ideas? Thanks Hi ...
...gas is for sure working up to the unit. Disassemble the pilot light tube and blow out with clean compressed air from a compressor. This should get rid of any residual water in there that is blocking ...
11 questions posted
Usually answered in minutes!
4 Questions
2 Questions
1 Questions
1 Questions