Midland 40-Channel CB Radio CB Radio "turn volume talking" Questions

back on radio do you have dynamic mic volume? if so try turning that up a little at a time and see if that helps.also do you have a volume control for talk back? if so turn it up to. hope this helps!!

...THE MIC GAIN, TRY ADJUSTING YOUR TALK BACK VOLUME ABOUT TURNING THE MIC GAIN FROM 12 OCLOCK TO 6 OCLOCK, DO NOT WORRY YOU WILL NOT LOSE ANY OUT BOUND POWER UNLESS YOU TURN THE MIC GAIN BELOW 11 ...

volume is not loud enough when someone talks or just idling. If if has a squelch knob turn it til it makes a hissing noise or rushing noise. then back to where the noise just quits. This is the proper

...Turn the volume up about 1/3, the squelch off or fully counterclockwise. You should now hear static or talking,if not something is wrong with the radio. As a last resort change to channel 19 and see ...

Radio transmits fine but the receive volume is way down. Can hardly hear it with volume turned up full. If you have talk back in this radio.( you hear your self through the radio when you transmit) ...

...volume and or squelch knob depending on the radio. Turn down or disable talk back. If you cannot turn off or disable talk back, lower mic gain. Try a different mic that you know is wired for cobra. ...

...turn down my talk back its too loud If it was an aftermarket install there may not have been a volume control put on it. Some times not even an on-off switch. To ad a volume control locate the jumper ...

...volume and people have to turn their set up to full volume to hear me. but the same mic on a different set works fine Look at Radio Mods or Defcom mods. To clip modulation diode inside radio. Take to ...

why my cb won't receive i can talk to people they can hear me but i can"t hear them. if they are very close to i can hear them turn up volume

...turn the volume wide open on my connex 3300 hpzx to be able to hear it . It recieves great but the volume is not load and i even tryed an extenal speaker on it The RX wire could be broke in the mic ...