Rowenta DZ9080 Iron with Auto Shut-off "repair screw" Questions

...screw driver. I had the unit repaired at an authorized repair center in Northern California and have been unable to remove it since it has been returned. He, if the repair was done within their ...

...apart, look for a point where you can insert a screw driver in it to pry the body part out. If you can't do that, then don't do it. best thing to do is take it to a repair agent. At least it's

Repair of Steam Iron Iron has a short circuit to earth and having taken the screws from the rear i find that the body is still attached to the base plate. How can I release the top body from the base ...

...screw driver that removes the screws holding the unit together At a repair center they quoted me $55 for the repair, while I bought a new switch (not identical like the original) for $1.50 and a ...

...screw (if you shake the iron, you may hear it rattle).. The iron is most likely good, just needs a 5 minute repair. If you want to do it, or find someone to do it: 1. UNPLUG the iron. 2. remove the 4 ...

be intimidated.  First, try to remove the screws with a tiny screwdriver from an eyeglass repair kit. If that doesn't work, get a Torx T-20 nutdriver attachment.    If you

screw", then you shouldn't be opening the unit. Unfortunately, when the heating element rocker switch gives out (3-4 years), it is usually about time to overhaul the entire iron (both the tank portion

...on the units so the do-it-yourselfers can not open them. I think they just do not want the units repaired and this is their excuse. They would rather have you toss the unit and buy another one. ...

Sunbeam iron model gcsbcs-212 troubleshooting unit keep turning off while ironing The iron is getting to hot internally and setting off the high limit switch. Since these cannot be repaired by design,

...is coming off loose from iron. How do I tighten the screw. broken studs for screw tightning,cant repair without expert,there is one screw under main wire side,second is under pressure knobs to open ...