Dyson DC17 Animal Bagless Upright Cyclonic Vacuum "roller bar spinning" Questions

...roller (called the beater bar). The beater bar will come straight up. Disconnect the belt and check the fittings at the ends of the beater bar... I'll bet that they don't spin easily (The fittings ...

roller bar does not spin how do I access the belt? the roller bar does not seem to spin It has a restart button that fixed the problem - I took it to a repair shop and they solved it. I have the same ...

...bar? thanks Either the touchpad is defective, or the motor is bad. My miele does the same after a few minutes. I have now deduced that the brush rollers stop because the motor gets hot. The suction ...

roller bar does not spin when turned on my DC14 Either your belt is broken or the roller is not functioning dues to debris or hair or bad bearings. You'll have to take a look at the bottom of the ...

...bar is bad. If the brush doesn spin, and it continues to break belts, this means that the belt is being installed incorrectly, and is being pinched by the roller brush. Pull the belt forwards after ...

Roller doesnt spin on my dc15 The brush doesnt spin anymore Hi there, it's Jack at Dyson. If your DC15's brush bar won't rotate, it may need resetting. In order to do this, please follow the steps ...

...roller (called the beater bar). check the bearings at each end of the beater bar (they must roll easily and smoothly). If they are bound up, pull them off of the ends of the beater bar and remove the ...

belt spins, roller does not the roller beater bar does not spin with the belt The belt has probably lost elasticity or the clutch needs adjusted or a new rubber pad.

...roller bar sits their should be a clear plastic tube check this tube is free of dirt. Check around inside the carrage for hair string etc. Check belt for breaks and swelling in the rubber pull ont ...

roller bar and the belt In the past when I have noticed similar issues with a vacuum of my own I found the the roller brush was not spinning. I see that you replaced the belt and roller brush already,