...beater bar by gripping the belt side of the beater bar and carefully lifting it out. • Remove worn or broken belt. • Clean beater bar and the end caps. • Loop new belt around motor shaft and beater ...
...beater bar belt or the motor shaft belt? If so, you need to set the vacuum in a horizontal configuration and turn the vacuum upside down. Next remove the five screws from the base plate and lift the ...
beater bar won't turn If you hear the motor in the head running and the beater bar isn't rotating, you probably need a drive belt. With the power off, make sure you can rotate the beater bar freely by
Question about Vacuums
beater bar that needed to be replaced. My beater bar has stopped working and I have tried all the normal causes; reset button, trying the beater bar with each segmant of the wand. Is there a fuse? and
...beater bar has seized. 1. Turn off the power (unplug). 2. Remove the bottom plate. With the plate off, use your finger to test the tension of the belt. It should be tight, and roll when you roll the ...
...beater bar, you'll see three large plastic screw heads. Turn these and youll feel the plate loosen. Raise the plate from back to front; it hinges toward the front. This gives you access to the beater ...
beater bar. Check the belt. Take care in removing the beater bar, so you can get it back in the same way it comes out. Clean the beater bar while you have the bottom open. If you remove the beater bar
beater bar switch on the top of the unit next to the on/off button does turn the green light on/off as it should, and the bar will turn(with a bit of resistance) by hand. (& yes I have tipped the body
...beater bar side up. Remove the cover base plate that surrounds your beater bar. It's held on with either clips or screws, and usually "hinges" toward the front of the vacuum to release when the ...
Question about Bissell Vacuums
...beater bar. This beater bar has brushes on it an extends the width of the vacum. Pull the beater bar out straight. Some times it is tight. Next is to place the new belt around the spindle in the back ...
1,106 questions posted
Usually answered in minutes!
1,132 Questions
870 Questions
655 Questions
597 Questions
450 Questions