Samsung HL-T4675S Television "instructions wiring lamp" Questions

...instructions. Follow this step it could help. 1. unplug your unit to main power ac input then remove the back panel, using a screw driver. Set the screw where you can easily find them when your done ...

...Instructions & Repair Service*** Hello, I hope the circuit board has been affected by a power surge or any short circuit which has caused this problem!..A burnt Ic or resistor might need some ...

instructions. It is really quite simple. I have changes mine twice in the 5 years that I have my 56" Vivitek. Start out by unplugging the TV. On the back you will see 2 screws to remove the lamp door.

...lamp according to the aforementioned instructions in the reverse order. 7. Turn on the projector and turn the lamp operation counter to zero. Changing a bare lamp without module: 1. Turn off the ...

instructions. It's designed for the customer to change. Replacing the DLP Lamp is actually pretty easy, all you'll need is a screwdriver, gloves, wire cutters and the new Lamp. Now the exact steps you

...wiring connections, unplug each one and inspect them for a bent pin. Let me know....tks The lamp must be reset when replaced. Check the owner's manual on how to reset. I had a similar problem and I ...

...lamp-disposal or recycling instructions. Do not dispose of the old lamp with common trash. 12. Reset the Lamp Reminder from the TV Setup menu as follows: a. Press TV MENU to open the Setup menu. b. ...

lamp. The TV will not power on. I used the original wires like the instructions said. I do notice there is a wire that is not connected to anything at the buttom of the house. Does that mean anything?

...instructions to install new lamp and reset TV. It was fairly simple. Basically you have 2 screws that hold on the cover panel on the right side of the TV. Once you take off the cover, you'll then see ...

...to id part number and see a photo----it will have two wires either red or black that go to the plug for the lamp----quite likely the You Tube will have video instructions for this