Magnum S9 Base CB Radio "fix meter" Questions

...be at it for hours trying to fix it. you will need a scope, frequency counter,watt meter, modulation meter, signal generator, volt meter,distortion meter,and a service manual from ...

...meter in it.Is their a potentiometer on the board that i can turn to fix that? Thanks Chuck. PS the radio was made in taiwan. there is a pot inside the radio to adjust the meter. if the meter did not ...

fix. The meter would have to be replaced. Careful when taping the radio, you don't want to cause more damage. If the meter is just gummed up, the meter is not integral, and if it doesn't mater

...meter in the radio it could have a bad detection Diode or just oout of adjustment or even a bad calibration pot. other wise start looking to fix your transmitter like finals or other similar

...meter on radio always stays on 2.5. I think other people are having the same problem. Is this a defect or is there a fix. i think it could be with the coax.try replacing the coax and the antenna and ...

...meter gage and the nobs, just wondering what could be wrong, and if I be able to fix it? Thanks Pete. It sounds as if you mean that your back-light on you CB has gone out. If that is the case usually ...

...meter to check. If if doesn't have any output that would be the cause of the problem.. then its another issues..May need some test equipment to find the fault on that one.You could send it in to ...

signal meter not working. is there a quick fix, for this problem is the meter good?

...that many, if not most, have problems.There are dry / poor solder joins all over the board.I fixed mine by reheating or resoldering all of the joins connect the vertical daughter boards and ...

...meter... i can fix it, just dont know where the wire goes thanks in advance! take your multimeter and go find it.connect one lead to the wire and the other serch for the point at which it connects to ...