...connection. There are two Thompson Speed touch modems. I connected these modems to Wan 1 and Wan 2 ports of RV042 router and I make these modems as Bridge and I configure RV042 as Gateway and also I ...
WAN hello, i have a DSL modem but it only has 1 port. then i bought this D-Link router D-Link DI-704P, it has 1WAN, 4ports and 1 parallel. what is WAN for? i have 2 pc's and connected it to ports 3 ...
...connection & traffic. Note The Teleco WAN 2 is a bit flaky, bandwidth varies from Max 3mbt/s to 200kbt/s. Any light you can shed would be welcome. Thank you. Try check with your subnets, if your ...
the wan miniport, Right-click on Wireless Network Connection > View Available Wireless Network. If you see several networks listed, highlight your wireless network and click Connect. That should do it
Dual Router Configuration Two D-Link routers in the following configuration: DGL-4300 WAN connected to ISP: WAN Address: by DHCP Mask: 255.255.255.0 Gateway: by DHCP LAN Address: 192.168.151.100 Mask:
...WAN connection to a Star Band dish. These dishes usually operate at half-duplex, and most ethernet connections, such as the WAN port of a WRT120N, operate at full-duplex. This may be the issue of why ...
Question about Dynex Computers & Internet
Trying to hook up router. What is the wan for and the 4 inputs The WAN port is the physical interface that provides input and output to and from the device that provides Wide Area Networking ...
no wan light dlink di-524. wan light suddenly appeared and i cannot connect to the internet. i tried using the router to another ip address/broadband cable but still no wan light If no wan light ...
...connection should be.. the ethernet cable from the the modem will go the the WAN port of the 1st router and you will connect another cable at the router1 on port4 going to the WAN port of the 2nd ...
460 questions posted
Usually answered in minutes!
1,179 Questions
1,053 Questions
455 Questions
426 Questions
369 Questions