Question about Audio Players & Recorders
...2nd speed is off 33 sounds like 45. One - bad belt or fitted wrong! - if belt drive!! Two - dirt/grease in mechanism or motor. Three - Oil or grease needed in motor or mechanism. Try and get ...
Question about Panasonic Audio Players & Recorders
...Hi this is John I'm hoping somebody can help me. I have a technicslinear tracking turntable and the grease has become sticky and driedup. The tonarm has a problem tracking the record because of the ...
Question about Sony Audio Players & Recorders
For the Sony PS-LX350H screeching turn table, where would I put the silicone grease? On the center spindle? That is the only moving part I see other than the spindle that turns the belt and I don't ...
Question about Dual Audio Players & Recorders
...drops slightly and then returns to its resting position on its base It seems that the special grease is old. There is a wheel moving the toneam. Remove any old grease from it and try again. If ...
Question about Audio Players & Recorders
...for the linear tracking tonearm so it moves smoothly back and forth? technics used special grease for lots of their products, any good quality grease will do but use ...
TECHNICS SL 1910 TURNTABLE SERVICE Tone arm lifter does not work properly The grease and lube in the mechanism will need cleaned out and replaced due to the "age" of table! The "lifter" may be bound ...
Question about Thorens Audio Players & Recorders
noise upon startup of thorens td 295 mk 4 turntable There is a brief grinding type noise when I start operation of the turntable. Check for dirt. Try some grease or oil. Silcone grease is best.
what brand of grease is used on old turntables? hi , I wouldn't use grease I would use a silicon spray its less messy and a dry lubricant so wont attract dust
dielectric grease need grease pitch up I use pepper sometimes, but i suppose you are a scratcher , try the tonearm somewhat lower, it irritated me also usung qbert on the 2000mk2...... and if you have
...timing is off for the gearing underneath the platter. It may be as simple as cleaning the existing grease on the mechanism and re-lubing. The existing grease may have gummed up a bit not allowing
33 questions posted
Usually answered in minutes!
325 Questions
254 Questions
185 Questions
116 Questions
103 Questions