...there is a round lip.put the belt around that. Then put the platter back on the table and turn the wheel until you get to the motor, which is the gold pin on the left, and put the belt over
...of your driver and adjust the belt from the down side of your plate where there is a circle.put it in there and grab the belt to one side and adjust it to the "turner"then put your vinyl and play
Question about Teac Audio Players & Recorders
...put the belt back on you must remove the pladder, but before you do check to see if there is a C clip holding it down, after removing the clip the pladder should come off, put the belt on the inner ...
...put the tip between the belt and the platter portion it's wrapped against. Pull the belt away from that( keeping the rest of the belt on the platter portion) and set it over the motor pulley. This is ...
Question about Technics Audio Players & Recorders
...put it on The belt goes underneath the turntable platter. First you attach to the lip on the bottom of the turntable platter, then you put the platter on the turntable. You'll see some holes on the ...
put the belt back round the runner on the platter,then put the platter back on, find the hole on the platter, then turn the platter until you see the motor wheel,put the belt over
...put the belt on to the motor pulley. First, put the belt on the rim of the platter. Hold the belt tightly through the hole in the platter and put it onto the centre spindle. Locate where the motor is ...
...put the belt round the little cog first then, start putting it on the big one, whilst turning the turntable! try that To replace a turntable drive belt. Copyright.. Styluscity.com, John Harrison. Nov ...
Question about Pioneer Audio Players & Recorders
...put the belt around the table inner bottom ring holding a little of the belt with a finger stretch it a little and put it around the drive motor and drop the bable onto the spindle and you are ...
Question about Audio Players & Recorders
...put the belt around them both and then put the plate on it (be careful, it's heavy). To replace a drive belt. 1, Remove the rubber platter mat to expose the platter. 2. Put your thumb and ...
213 questions posted
Usually answered in minutes!
415 Questions
267 Questions
266 Questions
148 Questions
138 Questions