...and see if lamp light goes red. If it does you have a bad lamp. Also check to see if lamp is on all the time. This a problem that can happen and service tech needs to fix it. Let me know what
...know for sure that the lamp is O.K., it would give me alot more incentive to try to find the circuit problem. Any help would be appreciated. Also, I did the tv built in trouble code action by ...
Question about Mitsubishi WD Televison & Video
...know my lamp is bad because there are pieces of glass inside the lamp. I replace the lamp but the green timer light keeps flashing. I have tried the reset button as weell as unplug the tv for long ...
...lamp right, but most likely the two 3300 and two 2200Ufd capacitors are bad on the power board. These routinely go bad after about 3-4 years of use on the tv. Parts are less than $10 bucks but you ...
Question about Mitsubishi WD Televison & Video
...lamp cartridge to bend the two pins it goes into out of the way.Also, in my shop if we see a lot of dirt coming out grill in rear we take the set on a cart outside with the rear cover off and use a ...
...lamp timer reset is not working properly. There is a button combination you have to enter on the front panel of the TV to do this (unfortunately I don't know what it is). If this doesn't work its ...
Question about Mitsubishi WD Televison & Video
...lamp (OK) 5) I have checked the current on the cable that goes to the ballast (ok 345v) 6) I have made a major inspection of the unit all cables connected I want to know if the problem might still be ...
Question about Mitsubishi WD Televison & Video
...Lamp enable line at connector J14 pin 6 on the Engine Driver PCB switches to 5 volts after turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the ...
...lamp and no change. I was told after a lot of research that there is a temp sensor for the bulb in the TV that goes bad or gets to hot due to a foam screen that's intention is to prevent dust from ...
Question about Mitsubishi WD Televison & Video
...know the solution is "simple"? No always is simple. Bussing is high voltage missing. Like is bad conection to the lamp. Check conections of it.There is some bad about the conections of lamp. I
190 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions