Question about Garden
...put new blades on it. Doesn't seem to get all the snow, and some shoots out the bottom at the back. Is there a way to adjust these blades? I have a Noma snow thrower, Model : G2145000. Just put ...
...put on the new blades I made sure to clean out the deck. Any suggestions? It is a 48" deck with 3 blades. With blades on and engine off reach under and wiggle each blade up and down. If you have ...
...new plug.starts fine but dies after i take out of park and put in gear or engage the blades ,held the blade engage switch down in park and engaged the blades it worked but when put into gear dies ...
Question about Garden
...new drive belt, installed the PTO and pulleys. Installed the deck and belts. I start the tractor, put in neutral, I push the button to engage the blades ut as soon as I put the tractor in drive, the ...
...deck belt so you know how to put it back on after you have the new mandrel bolted in. if it is old you may just want to replace all the mandrels while you are at it. they are less than 50 bucks
...put on the new ones the right hand side one hits the deck. What could it be (checked the blades they are the right ones) Probably bent jack shaft or bearing. Or the deck bent, where the bearing is ...
new blades put on it by a vendor and since then, I have a 1'' gap of grass between the two blades that doesn't get cut when I mow the grass? How can this be fixed/adjusted? It is a 15.5HP with 42''cut
Question about Craftsman Garden
...a special way? use the blades for leverage when loosening the bolts. when putting new blades on, hold the blade in the star center hub install washer and bolt. use blade for leverage when
...new blades on ,could we have put something back to gether wrong With mower off check the blades, its easy to put them on upside down which kills the cutting and bagging. Just had the same problem and ...
...put new one on,to remove blade put a pair of vice grips on the body where the blade can stop and not turn it is usually a 9/16 or 1/2 socket, put blade on add oil,add new and fresh gas,you should be ...
396 questions posted
Usually answered in minutes!
379 Questions
286 Questions
107 Questions
45 Questions