Black & Decker 19" Electric Lawnhog Mulching Mower with Rear Bag "blade clamp" Questions

...will likely need a breaker bar or a large ratchet, as it can be quite tough to remove. You can also use a c-clamp to clamp a smaller block of wood to the inside of the deck for the blade to bite

...useful. You can also use a c-clamp and a few inches of 2X4 clamped to the side wall. The idea is just to keep the blade from rotating while you are loosening. I hope this is really helpful for

I need to get the blade of the lawn mower sharpened.Any tips on how to disconnect the blade fropm the lawn mower? There is a jig that you can buy that makes this job SO much eaiser. It is a universal ...

...order. If the blades turn while you are trying to "break" them free, you can use a small 2x4 block of wood or a c-clamp on the side of the deck to hold the blade from turning until the nut is freed ...

...blade on. You can also use a C-Clamp if you have one available or just about anything else that will prevent the blade from turning while you are loosening or tightening it. Put the new blade back on ...

blades won't turn to cut grass I just purchases a new mower (Ariens 1334 Zoom). I can get it to run but the blades are not turning. What could the problem be? On the chute where the grass comes out ...

...all wiring including ignition switch and problem continues. Runs when first started then when blades are engaged motor begins to backfire constantly and will not stop even if blade are ...

blade to hold the shaft in place when losing the bolt at the top of the shaft and pulley. Any tricks or suggestions? You can use the belt to hold the pulley from turning ( you ARE going to replace the

clamp onto the under side of the deck and then rotate the blade around against it. This will stop the shaft from turning while you remove the nut. If you have already removed the spindle assembly from

...or a large c-clamp to stop blade rotation also by clamping to side of deck. Then you should have no difficulty removing the nut from the spindle releasing the pulley. If really helpful, please