Question about Craftsman Garden
Craftsman Wee trimmer will only run when tilted on its side. I have a craftsman weed trimmer about 8 yrs old. runs only when tilted on its side. we cleaned out the fuel tank, installed new fuel lines ...
Question about Garden
...line on left with filter attached goes to bottom port of carb, fuel line from right side coming out of tank with inside tip attached goes to bottom port of primmer bulb,top line on primmer bulb goes ...
line with filter goes on nipple at pump side of carb and other nipple goes to suction side of primer and other nipple goes to tank as a return line ...so as you prime it, this causes fuel to be sucked
...line and cut to fit. If the filter is bad, use a new kit. Insert through the gas cap opening and pull up through the supply line opening. Be sure the connection is clean then slip the new line onto ...
line was brokened. replaced both fuel lines and now it won't start. tried starter fluid, only ran enough to burn out starer fluid. 1.You have to remove the air filter *** cover. 2.Remove air filter. 3
...line to the carb has fuel filter on the in-tank end and that it is clear. Make sure there is spark at the plug. Make sure your air filter is clean. Make sure the bolts to the engine cylinder and the ...
filter go on? The line that primes the engine(with the little pump) or the other line!! you want the filter keeping the inbound fuel clean to the bulb and the carb... the other line should be a return
Question about Garden
filter screens can not be cleaned; only replaced.
Here is a basic line plumbing diagram just for reference. If you carburetor has the primer built-in just the primer in the diagram as a line.
...line and filter. Don't let line fall back into tank. find somthing to hold it so not to damage line. Or ask a friend or family for a hand clean filter with carburetor cleaner, replace filter. fill ...
cleaning. Remove two screws at the side of the filter housing (has the choke control through it) and remove filter from inside. Clean in water with detergent. Allow to dry before saturating with 30SAE
347 questions posted
Usually answered in minutes!
300 Questions
122 Questions
96 Questions
40 Questions