...back up every time I try to close it. It will not go all the way down even when the button is held down to by-pass the sensors. We've tried adjustng the pressure and the travel distance. The door ...
Question about Sears LiftMaster Building Materials
back one near the lift stops the door before it contacts the motor housing. The Infra red beam controls down near the floor with red and green diodes stop the door when an animal or a child breaks the
Question about Sears LiftMaster Building Materials
...down. we had to manually close it. once it was closed and we press the button on the wall the motor sounds like it starts and the stops real fast the door never moves. HELP Make sure Carriage is ...
Question about Sears LiftMaster Building Materials
...slides back and forth on the rail and is connected to the door) is jammed against the bolt just in front of the motor unit. If so, remove the bolt and run the door until it is closed. On the side of ...
Question about Sears LiftMaster Building Materials
...DOWN AND POWERED OFF. THE OWNER'S MANUAL DOES NOT SAY WHAT THE BLINKING LIGHT SIGNALS. I'M AFRAID IF I TURN IT BACK ON IT WILL BE DOING THE SAME THING OR IT WONT CLOSE. HELP. THANKS AG56 Anytime a ...
Question about Sears LiftMaster Building Materials
down the shaft. All this above assumes that you've got the rpm sensor plugged in and there are no other issus. All this is over my head! I had the same problem. After reading all these suggestions and
...back a foot to the closed door position. I fiddled with the two pressure adjustments and pulled the plug out of the outlet for few minutes. That didn't change anything. The sensors at the bottom ...
Question about Sears LiftMaster Building Materials
...slides over the rail) that pushes the door down seems to be jolted at a connection joint of the rail. At first it made a banging sound but closed. Now it hits at the same spot and the door goes back ...
5,971 questions posted
Usually answered in minutes!
0 Questions