Karcher 2500 PSI Pressure Washer "runs shuts trigger" Questions

...runs for about five minutes then just shuts off. Engine restarts fine but when trigger is depressed engine shuts off looks like the fuel cap may not be venting try it with the cap loose allowing air ...

shuts off common for not starting unless trigger engaged as you are turning the pump as well as engine creating pressure,as for stalling pump has unloader valve which is probably in need of grease(use

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left ...

trigger it makes that very loud humming noise and the plug box (with the Test/Reset buttons) gets VERY VERY hot until the machine shuts off (takes about 2 minutes before it shuts down). Then I have to

shuts off when the trigger is released. But now (after using it for only 6 times in its second year) the motor runs continually when the high pressure washer is turned on and the trigger of the gun is

runs fine but shuts down after about 3-5 minutes on squeezing the trigger, it songs like its not getting fuel n shuts off when trying to restart got to start withe the choke Sounds like the fuel inlet

i just bought a 2nd hand honda excell psi max vr 2522 2.2 gpm max 5.5 hp gvc160. i put gas and oil and it wouldn't start? Have a helper hold the trigger of the wand open while you try it again. If it ...

...the unit with the wan trigger engaged water coming out to spray. If the unit runs while wan trigger is engaged and shut down when released your unloader valve isn't working. Hope this helps God ...

Runs fine until I pull the trigger thenb it shuts off Starts right up. The oil is at the level it should be the screen is clean. Only when I pull the trigger is when it shuts down, Was running fine ...

I have a honda 2600 pressure washer. After running fine for a couple of seconds the water will stop flowing out the tip. It is receiving water,but will not flow it to the pressure hose. I even ...