...wood. You can try cutting at a slower rate. I've found that makitas are a little more solid through the cut, though I don't like the general ergonomics as much... Kind of a pain, isn't it? Well, good ...
Question about Powermatic Saws
...cutting in the angle. maybe the teeth on your blade are dull on one side and the blade is pulling material to the side. maybe the fence is ok. There is more than one ...
cutting some wood without any problems. It sat for a half hour and I went to use it again and it was running half speed then before I could even turn it off it just died. There was no popping sound or
5) The saw fence isn't set straight causing the wood to jam as you push it into the blade. Check this with a framing square and readjust so it is at a 90-degree angle to the front of the saw table
...wood that I cut is on a slight angle. If the saw blade actually angled far enough to hit 90 degrees (or even 91 degrees), then I could use a T-square to line it up perfectly. Is there another area on ...
Makita LS1013 Sliding Compound Mitre saw will not lock at chosen positions/angles on the turnplate other than the standard stop points. Turning the handle will not lock the turnplate anymore it used ...
...wood and trial and error. It takes a while, but you can get a perfect result. If you are using a miter saw, then support your work from underneath at the angle to match your situation, and simply cut ...
63 questions posted
Usually answered in minutes!
40 Questions
32 Questions
33 Questions