Behringer EUROPOWER EP2500 Amplifier "amp clip lights sound" Questions

...CLIP lights remain on. The clipping light is a warning when volume is set to high you get advanced notice the amp is about to go critical, now if everything is fine in the sound department it ...

...amp has lit the clip light, control light but not the signal light. initially it was ok but all of a sudden, they went to operate it and it showed the above faults. I have checked mosfets in the ...

...clip lights do not light (yet), when this occurs. Doesn't seem like the variable speed fan is increasing properly but vent air temperature does not seem excessively high (only warm) either. No air ...

Amp clip light is always ON only the left channel and the same channel is not functioning by giving sound, please help I had used it for 1 year and after it began to show the clip light. I looked at a

CLIP light blinks a couple times and the FAULT lights blink until a loud "CLICK" sound is heard and the unit turns off. It's very likely that the main power amp section has a faulty part on it that is

...Clip light Channel 2 stays on & heatsink HOT! Tragic moment happened when I only had one amp to play for a college exam week flash rave (May 6 2010). So, that said, the amp is a Behringer EP2500 ...

clip light will go on then goes off one speaker will not go on The problem sounds like a dead short issue and the amp is in protection. Check cabling to make sure there are no crossed wires. You can ...

...amp the output became very low, also the sound is not normal the sound is clipped and towards to high treble. I removed both the RCA cables to the pre amp and slowly touched the RCA pin to induce hum ...

...CLIP, on each chanel apears. The sound is ok but after a few minutes, the amp turn off itself. It can be restarted after 15-20 minutes. I have tryed to load other presets or change the input ...

...amp? (check them again) Are you certain you have an input? (AM, FM, CD, AUX, other) (Make sure the input is turned ON and the source is properly selected. Is the output protected by a fuse or fuses? ...