jumper setting SATA drives require no jumper settings
...just above that block of pins. Look for 'MA(ster)' and 'SL(ave)' and 'C(able)S(elect)'. Remove any jumpers, and then put a jumper at the 'MA' pair of
...jumper contactor, nevermind just use what ever conductor cable to roll between the two pin and make sure the pin is connected that all. YBC (/\) Hello! Here are your jumper settings: Hope this
Question about Maxtor Computers & Internet
...also, if one is set to single drive it will likely bypass the slave drive. Here is the link that will teach you on how set your jumper settings easily from IDE to SATA maxtor hard disk ...
...jumper settings are marked on the circuit board. MA = master SL = slave CS = cable select If this hard drive is the one installed on the Primary IDE controller the the jumper has to be set to Master. ...
...jumper settings for each kind of drive. Serial ATA drives don't need master/slave jumpers. You can choose "computer select". In fact, you should be a ble to run an ATA drive with no jumper. When you ...
...jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on the top ...
...DS = Master SP = Spare (Slave) Jumper settings, If you use one id cable with tow devices at that time you should hard disk jumper master & second device slave mode of jumper. hard disk ...
Question about Maxtor Computers & Internet
jumper settings for slave drive model 33073u4 30 jumper settings for slave drive model 33073u4 30 gig hello go to this link.. it will illustrate jumper setting http://sysdoc.doors.ch/MAXTOR/diamondmax
...jumper settings for model 7245At maxtor hard drive jumper settings for model 52049h3 1. Jumper settings for model 7245At refer to LINK 2. jumper settings for model 52049h3 refer to LINK Hope it
32 questions posted
Usually answered in minutes!
12 Questions