Altec Lansing VS3251 Speaker "low" Questions

mackie 450v1 when i turn on low cut switch the sound stops turn off low cut and sound returns my mackie 450v1 if i use with sub or on own when the low cut switch is used the sound stops and returns ...

low pass crossover what does this do for me Low-pass crossover Both sets of inputs sum the left and right channels together and the resulting signal is passed through an adjustable low-pass crossover ...

...to a normal front channel (or rear) just like any other speaker would. However, the red/black (low frequency) need to connect to a dedicated LF connection. Most receivers don't have this output. ...

speaker. This means it has a built in amplifier. These active subs usually provide for one or both "low level" and "high level" inputs. Low level signals are usually carried by shielded coaxial cables

...and 4 speaker wire outputs which I am assuming are right and left channels. There are two other low inputs, one is mono. Lastly a power switch and volume but I'm still clueless. Forget the 4 wire ...

klh powered sub woofer what are the low level plug ins for?...these are rca pin plugs Low level inputs are designed to take signals directly from an amplifier's "sub out" connections. That way the KLH

too much bass...low end i have sw 150 and hooked it up to my denon dab 37. problem is too much low end bass....any ideas? Hi, have you tried adjusting the "subwoofer level", and or the "subwoofer cut"

No low end amp faiure No low end possible causes: Woofer defective LF amp defective

Sound is very low Every thing is turned up to max but sound is still low What are you using for the sound source? That could be where the volume is being lost. Here is a troubeshooting guide. ...

how to adjust volume on left speaker? volume is extremely low on that side. Its most likely the balance or fader that is causing the volume difference. set both of them to the mid setting ( usually ...