...faded,do i need to clean this printer if i do,then how do i do this,or is here something else i need to do, # Hold the cartridge upside down, with the bar-code label facing you and take a damp paper ...
Question about HP PhotoSmart Office Equipment & Supplies
...label. You will see 5 holes. The one on the top is for yellow. The two holes on the left are for magenta (red), and the ones on the right are for cyan (blue). Here is a picture: Slowly pour 3-5ml. of ...
Question about CardScan Office Equipment & Supplies
...profile information and when I went back to look at them (within weeks) they were almost completely faded. Some may have gotten wet, but many had not. What can I do to preserve these labels? TRY THIS ...
Printing fade at the midle of the page Hi there, I was making some testes printing labels with my Zebra S600 and everything was going just fine. But, when I finaly got the label printing out just the ...
ink is fading on my qx50 After using my qz50 through approx. 5 refills the ink is fading. Can I purchase another? Dymo Labellers don't use ink, they are thermal printers. When the print fades it ...
when typing the print is faded Dymo LetraTAGs are thermal printers, so they don't use ink - just batteries and LetraTAG tapes. When the print starts to fade it's time to put new batteries in. When the
I seem to have run out of ink in my DYMO letratag. Can I refill? They don't use ink, just the label cartridge. If the print is fading, replace the batteries: Troubleshooting Poor print quality on Dymo
Question about Zebra Office Equipment & Supplies
The printing is fading, more so on left of label, but also on right side of label Try cleaning the thermal print head. If that doesn't do the trick, the printhead may be defective.
...faded, but the rest of the label is printing perfectly, and I changed the ribbon as well. Please help On the right hand side of the print head is a blue thumb wheel. ensure this is set position 9, ...
label bar is faded at the top. This is consitent throught the entire barcode label. best guess would be a thermal printhead has an element out and needs adjustment. However with out a model number and
1,041 questions posted
Usually answered in minutes!
1,869 Questions
1,438 Questions
484 Questions
508 Questions
488 Questions