Mackie SWA1501 Subwoofer > Search
Mackie SWA1501 Subwoofer impedance
You have A and B output on your amp.For example you can connect two speakers on A and four on B but first check impedance of the speaker.Use four pioneers but make serial connection (+ wire of one speaker goes to +Rout,-of that speaker goes to + of another more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
= Poor
= Average
= Good
= Excellent
You only need the impedance of the speakers, power rms, and mounting hole size. Go here and mix and match their huge selection. http://www.parts-express.com/speakers.cfm more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
of stereo speakers is possible, but it requires an external speaker selector that both provides more speaker outputs and protects the receiver against low impedance loads.
Tip: Many receivers will not let you run the "B" and surround speaker outputs simultaneously. more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
Can speaker with max input power 25W, Impedance 8Ohm replace speaker with max input power 90W, Impedance 4Ohm Hi Expert, I have a stupid question in regards of 5.1 Sound System. I more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
bundles of speaker wires disappearing into the walls, and also a big JBL subwoofer sitting in a closet. How can I figure out the impedance of the speakers so I don't mess up my receiver; how do I know which wires go to which speakers, and how do I more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
those lovely "highs" from somewhere among the electronics by means of additional super tweeters/ crossover networks that can be safely connected across 4 ohms impedances without more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
or a faulty cross over, or both. If you have a
multimeter, you can remove the tweeter, and check it DC resistance.
They normally have their impedance marked on the back of the magnet.
If not, you can assume they should measure 8 ohms. If they measure
open circuit (high resistance), then they more...
Mackie SWA1501 Subwoofer - Troubleshooting
- Rate this result:
- = Poor
- = Average
- = Good
- = Excellent
Sponsored Links
Wiz
Repair Service
Find Home Theater Spe. Repair Service Provider Near You:
About | News
| Contact
| Find Products
| Find Cars
| Terms
| Privacy Policy
| FAQ
Advertisers | Tags | Blog | Repair Service Directory | Partners | Careers |
Advertisers | Tags | Blog | Repair Service Directory | Partners | Careers |
