...slams into the left-facing inside with a terrible bang. Then won't print, I get error message on machine, etc. There are two blinks of the light, but I tried the solutions to two-blink ...
...carrier that you will not be able to see. Reach in with the first finger of either hand and carefully strum the strip as if playing a guitar. The strip will need to be lowered slightly and brought ...
Question about Lexmark Office Equipment & Supplies
carrier slams up against back???? Won't stop!! It's a new printer, put in a high cap black and low cap color cartridge. Any ideas how to fix this? Cartridges may not be seated properly. Remove all the
...carrier slams back and forth with great force and then I get a carriage stall error message when trying to print. "Carrier stall" Error and the Carrier Slams in the PrinterID:ENUS12078 If the printer ...
...carrier slams again and you get the same message. How do I fix it? Hi, Please do the following.. To check the cartridge carrier: Unplug the printer. Move the cartridges to the left by hand and then ...
lexmark x83 carrier stall the error reads carrier stall, press power key. when power key is pressed, the printer cartridges SLAM, with alot of force, all the way to the left. The the error reappears. ...
Question about IBM Office Equipment & Supplies
...slams to one side then all the way back I gert an error message to start it again and slam bam. I hope you can help. The encoder strip may have come out of the sensor slot. Turn off power, slide ...
Question about Lexmark Office Equipment & Supplies
...shoots across and when i press copy the carriage shoots across and hits the right side with a bang, carrier jam appears on the top of the screen and below a note_clear the carrier jam.there is no jam ...
Question about Lexmark Z Office Equipment & Supplies
...stall- the cartridge carrier slams hard left every time I push the checkmark button. Nice job on cleaning the encoder strip. Please contact Lexmark Technical Support Center for additional
...carrier slams all the way to the left with a lot of force. The printer worked fine all I did was replace the cartrige. The power button from that point on did not even work I have to pull the plug to ...
21 questions posted
Usually answered in minutes!
280 Questions
231 Questions
151 Questions
114 Questions
115 Questions