Question about Xerox Phaser Office Equipment & Supplies
...Head Maintenance Clutch, PL 4.0 I/O Board (2/2), Figure 10 Table 2 Printhead Restraint Fault 7,010.xx through 7,015.xx Troubleshooting Procedure Step Questions or Actions Yes No 1 Reboot the ...
Question about Xerox Phaser Office Equipment & Supplies
What is system error 07,010.43:136328 The code means that the head tile restraint spring is not in place. This is what engineers check for before replacing any parts: • Check that the Process Drive ...
Question about Xerox Phaser Office Equipment & Supplies
...every page. The ink so thick you can peel it off. ERROR code 07,010.43:12217 That error means the head tilt restraint is out of place. It sounds like there is a problem with the print head. Either ...
Question about Xerox Phaser Office Equipment & Supplies
...restraints rotate correctly? They are black plastic peaces that pull the print head back to it's home possition. Replace the print head restraits. make sure no ink is spilled in the printhead area ...
...warms until 40% and then shows the message. I have read somewhere that is a something with printhead position. I have checked 1.Printhead 2.Whiper Drives , and clutch. Ameally out of ideas what ...
Question about Xerox Phaser Office Equipment & Supplies
...restraints are not broken. 4. Check for an obstruction or damage in the process gearbox. Ensure the gears are correctly aligned and homed. If faulty replace the process gearbox assembly. 5. Run the ...
Question about Xerox Phaser Office Equipment & Supplies
Restraints. 3 Has ink spilled ink around the Printhead that prevents the Printhead from moving to its center position? You should be able to push the Printhead right to left. Clean the Printhead area.
error code 07,015,48:94562 That error signifies the head tilt restraint is out of place. There is a kit that solves this error, the part number is 8560-Z2. http://www.iteminconline.com/itemdesc.asp?ic
...head restraints. There are several possibilities. First. The right or left print-head restraints often crack not holding the print-head in the restrained position. Remove the side covers and you can ...
...will work fine. Harry The 7,007.49, 7,008.41, 7009.42, and 7,010.43 errors indicate that the Printhead was unable to tilt normally on its axis. Possible causes include: ■ The printer was ...
548 questions posted
Usually answered in minutes!
284 Questions
262 Questions
152 Questions
147 Questions
158 Questions