...supply)is faulty. if the fuse is black inside it means there is a s/c on the psu if the fuse is clean it generally means a faulty component on the board. Either way replace or repair psu.
...Erro C- 3451 Y Doing hi please check your fusing unit is inserted correctly then check that your PSU and PWB-M connections for your fusing is correct if this does not work change the fusing unit
Question about Toshiba Office Equipment & Supplies
...may be a software problem check it out through expert of the company i am a toshiba engineer, you have no 24volt supply from the psu. check the fuse on the psu. highly unlikely to be the door
...operation (below 140°C) or during standby mode Possible Cause: Fusing thermistor defective • PSU defective • Bad connection between fuser and ...
...pressure roller temperature stays at 200°C or more for five seconds. It could be: ? Defective PSU ? Defective BCU You did the first thing, you will need to try the other two. 1. Replace the ...
...below lower limit (155°C) and remained below limit for 6 seconds. • Fusing thermistor defective • PSU ...
...temperature remained above 230°C for 1 second. Possible Cause: • Fusing thermistor defective • PSU ...
...overheat The detected fusing temperature stays at 200 °C or more for five seconds. Replacetment the PSU. Got it here: ...
Question about Dell Office Equipment & Supplies
...pressure roller temperature stays at 200°C or more for five seconds. It could be: ? Defective PSU (power supply unit) ? Defective BCU (The BCU generates the FGATE signal based on the ...
fuse which needs to be changed and if so, where will you find it. thanks This sounds like a classic psu fault this is found under the fuser unit on the back of the printer planty are available on ebay
275 questions posted
Usually answered in minutes!
995 Questions
574 Questions
608 Questions
501 Questions
509 Questions