...feed frame cover. (6) Remove the Holder bearing MP. Lift up the Lift arm MP to release it from the Pin of the MP roller holder ASSY. (8) Slide the MP roller holder ASSY to the direction of the arrow ...
...I see a couple of dozen metal pads on it where it interfaces in the printer. But I don't see any pins. Can you tell me what you're looking at? When you take the printhead out, you only see the ...
Question about VeriFone Office Equipment & Supplies
...Pin Pads or terminals with internal Pin Pads). Since the 3200 only uses external pin pads and they can be PCI compliant Pin Pads then the terminal is fine. (The 3210 however is non-compliant sine it ...
Question about VeriFone Office Equipment & Supplies
hp 7210 removing pad for cleaning how do you do it? How do you remove the pad that is sopping up the leaking black ink? Just pull it out? I removed the cartridges, moved the carriage to the middle and
Reset users pin Hi, I need to reset all the user pins on my Minolta DIALTA DI152 Copier machine. Could you help me please? Cecilia Settings for the Administrator Mode 1 Call the Utility Mode to the ...
...the lid of the printer to reveal the cartridge track and ink pad. Winkle out the ink pad, using a pin or a small screwdriver or tweezers. Wash the ink pad in clean water, squashing the pad to
...parked position. If there is a plastic cover over the absorber, remove it. Then take a straight pin and pull the absorber pad out. Wash out the excessive ink and let it dry before
...is installed normally. (2) Check if the charger wire is broken. (3) Check if any of the connector pins of the charger cleaner front/rear position detection switch is disconnected. (4) Check if the ...
...pads and the squeegee could move back and forth again. and will clear ur issue there is a safety pin lodged under the far right side (home base). gently push the unit to the left to expose the ...
Question about Rimage Office Equipment & Supplies
i have a rimage prism plus why are my disc not clamping in on tray Usually this is a bad printer pad, or your disc are not flat? Put the disc on a table, push near the edge of the disc and the ...
129 questions posted
Usually answered in minutes!
20 Questions
14 Questions
11 Questions