...tray there are two compression springsapprx 1/2" in dia. Gently prise apart the 2 flap pivot (on the extended arms) to gain access to the springs ,pull out the springs and either replace them with ...
Question about Panasonic Office Equipment & Supplies
...tray #2. You will not be able to use your tray #2 until it's fixed. You can check it, sometimes there's just paper clogged at the rear of the paper tray. Remove your 2nd tray to see if there is a ...
Question about Samsung CLP Office Equipment & Supplies
...tray 2 is not lifting the paper up to the feed rollers.pull the paper out of the tray and make sure it is not folded up the side of the stack if it looks ok then you may have a failed lift motor or ...
...tray 2 pre feed sensor". You say that you " tried changing Rollers,and all the sensors". I'm confused, does that mean that you tried and couldn't change the sensors. You could also have a bad paper ...
tray 2 and is everything ok, but i still receiving this message and i cannot print. Please any help? C0204 as I see you already know is a tray 2 elevator failure. Meaning the machine does not see tray
...tray #2. You may check the tray. Sometimes there's just a paper clogged at the rear of the paper tray. Just remove the 2nd tray to see if there is a paper clogged inside. Otherwise the cover/case of ...
Question about Panasonic Office Equipment & Supplies
...tray #2. For sure this time you can't use your tray #2. you may check it sometimes there's just a paper clogged at the rear of the paper tray. just remove your 2nd tray to see if there is a paper ...
...how do fix it. not familiar with the model number but H codes usually refer to paper tray lift failure - H2 tray 2 etc.H1 tray 1- are all your trays working ? Actually H codes refer to a fuser
...Tray 2 Elevator failure - The Lift-Up Sensor is not blocked even after the lapse of a given period of time after the lifting motion has been started. 1. Turn OFF the Main Power Switch.2. Turn Main ...
...tray 2 is not lifting the paper properly. Most often this is caused by the tray being loaded improperly. So to try and fix this I would open tray 2 and check the loading of the paper and correct if ...
1,096 questions posted
Usually answered in minutes!
374 Questions
221 Questions
108 Questions
110 Questions
74 Questions