Brother DCP 130C All-In-One InkJet Printer "replace close back cover" Questions

...replace the broken parts. This requires some degree of mechanical skills in knowing how to disassemble and reassemble your printer safely. If it is beyond your capability, you may have to let someone ...

replace the drum unit with a new one. This message would continue to appear if the drum counter was not reset when you replaced the drum. To reset the drum counter, follow the instructions below: Open

close front cover Drums have a finite life on all laser printers. The 7040 has a drum life of 12,000 pages. This is a firmware setting built into the printer. The error light comes on before you reach

...back cover open message. Close the cover and the message goes away. Any suggestions? Eject sensor actuator is too short or the main board is defective Recommendation: Either the eject sensor actuator ...

back in, did you remove the protective cover and clean coria wire? http://welcome.solutions.brother.com/BSC/public/us/us/en/faq/faq/000000/000000/000065/faq000065_018.html?reg=us&c=us〈=en∏

...Close back cover" on Brother Dcp 7020 printer Hi, This error is due to tray problem check if the back tray latch is not broken .also check the Fuser unit at the back if its not been fixed or loose ...

replace toner massage i replac but did'n toner ended problem for DCP 7055 toner ended how fix Have to do the key sequence fairly quickly or it defaults back to the "COVER IS OPEN" message. 1. Open

...replace it. If this is a new cartridge, try following these steps. 1. Unplug the power cable. 2. Remove all 4 ink cartridges. 3. Close the ink cover 4. Plug the power back in. 5. Wait for the machine ...

...replace the cartridge assembly into the printer, angle the cartridge at about 45 degrees and rotate in while pushing. It should click into place. If the front door then closes properly, you should ...

...replace the black to which i have taken in and out several times and it say's the rest of the colors are near empty. no mater what i try to do it just beeps at me If you still need help: ...