Xerox Phaser 6180N Laser Printer "confirmation fax page printing" Questions

after sending a fax I would like a confirmation page Xerox phaser 6180N is not a "combo" device but a printer alone. You should check with your fax software how to print confirmation pages.

fax confirmation sheet on a Xerox Phaser 6180MFP Not quite sure what you mean here, it can be switched either on or off within the internal settings. Normally the default would be off in a large ...

...printing and clear anything in its memory buffer. Please comment back here to this page if you have any questions or just require further general assistance and I will respond as soon as I see it. If ...

...Fax Confirmation for all fax sent and received. HP Officejet J4680 All-In-One Hi, Follow the steps below to enable the Fax confirmation on Sent and recieved. On the printer : Press Setup ( ). Press ...

FAX CONFIRMATION PAGE I set my HP M3027 MFP to print the T.30 report after sending a fax as confirmation that I sent the fax. The problem is it prints 3 pages, wasting paper. How can I set the machine

Fax sent confirmation report. Press Setup ( ). Press the right arrow button ( ) to select Print Report , and then press OK . Press the right arrow button ( ) to select one of the following options: On

...fax How do I print a confirmation page for the Cannon 710 fax machine? 1. First You need to press the additional functions button on the front. 2. Select Report Settings button 3. Select Printer ...

...confirmation each time a fax is sent, follow these instructions before sending any faxes and select Send Only. To set automated report options from the control panel Press Setup. Press 2, and then ...

...FAX Confirmation printed out on the HPJ4680? If you require printed confirmation that your faxes weresuccessfully sent, follow these instructions to enable fax confirmation beforesending any faxes. ...

fax the printer sends out a confirmation page. I can't find where to turn it off. I did find a blurb that says to Turn off scan TX Report, soft sw 368 set bit 1 to a 0. I don't know where or how to do