** I am suspecting the Main Board. *** Please Advise me of a Solution. Sounds like you have a fuser failure. Check the heater lamp, thermal fuse and thermistor. One is probably bad
Question about Xerox Office Equipment & Supplies
... and what would a memory module typically cost. From what I have discovered having had a total head failure, which the printer did not report, even though the prints were heavily lined, the printer ...
Unit wont start up after power failure Having same problem as Nonickname's psc 2410: That is, after power failure w/ psc 2510 running XP sp2, unit wont start up. Unit powers up then the hourglass on ...
Question about Xerox Office Equipment & Supplies
failure to initialise, print, clean error report usually indicates the waste ink chamber is full and the purge count has maxed out. You can remove the waste ink chamber, clean and replace the pads and
Question about Xerox Office Equipment & Supplies
...- EEPROM info print 2 presses - green light - EEPROM initialise 3 presses - orange light - reset waste ink counter. hope this helps this is hardware failure it is good if you show it service
...all the panels on the front. However, this does not solve the problem. The manual suggests a fan failure. The printer was opened and indeed one of the fans on the left side did not spin-up. Now Im ...
...you can do pushing buttons. There may be any number of reasons why the init would stop, a motor failure, a problem on the logic board itself. The final outcome could be that fixing requires a lab ...
Question about Xerox Office Equipment & Supplies
...initialise and settle down after some time, > Clean the cartridges and printheads of the printer. Follow:- < ...
Question about Xerox Office Equipment & Supplies
...failure 19.1' comes on. Hi guys, When I start the C2424, it goes through it's start up routine checking ram, usb etc. When it comes to the check on the disc drive it, fails that check with the above ...
...stuck and aren't moving . This noise goes on for approx 1 - 2 minutes then message says" Scanner failure - turn power off". I have tried cleaning all the bits I can get to, partial reset and ...
220 questions posted
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions