...wire unit You dont connect all five wires. One is a common so find common on motor and make that connection, next is the heat tap, connect this to med. on motor and last is ac tap, hook this tap to ...
Question about Goodman Heating & Cooling
...common causes for that are as follows. 1) a blown fuse. (usually a blade fuse mounted on the board) 2) a broken/loose/disconnected wire. 3) a bad 24V transformer. When the unit loses control voltage ...
...wire from the common terminal of the old capacitor, connect the other end of the white jumper to one (doesn't matter which one) of the terminals of the new capacitor, connect the white wire from the ...
...Yellow wire (AC condensor) C = blue wire (common) O = Orange wire (reversing valve) W1 or W2 = White wire (emergency heat) For gas furnace W1 = white (gas furnace) R = red G = green Y = yellow C = ...
Question about Dometic Heating & Cooling
...Common" wire on your fan motor (this means its Common to all the other connections inside the fan motor to me. It is usually white. Connect this to the other line of power usually the Com on the ...
ac supply house. I'm going off the info you provided. humming can sometimes just be the transformer and you could have a blower relay issue. I have provided the most common issue that I find with this
...wire on the control board low voltage terminals R and G your fan should come on and run if you have 120v power to fan motor. double check that you do have 120 leaving board and going to motor. if no ...
...wire is usually the common. you should always check to see how it is wired at the board or relay in the unit. not everyone wires it by the colors. If your fans low voltage wires are touching the low ...
Question about Heating & Cooling
...wire diagram should tell you how. it all depends where wires lead to. be very carefull, capacitors can be dangerous. brown usaully go to fan black usaully goes to common red usaully goes to herm or ...
...wire of blowing fan.Check how many leads make sure to make sketch where it was connected from low,medium, and high there is coded color on it,discannect from the terminal, using clamp ammeter set to ...
48 questions posted
Usually answered in minutes!
7 Questions