Bissell 1698 PowerSteamer ProHeat Upright Wet/Dry Vacuum "bissel 2 put water" Questions

...put water in the other bissell 12amps shampooer,cause i have 2 of them and it wont shoot the water out when i press the yellow thing on the handle.the water just stays in the bucket it doesnt even go ...

2 x will not pick up water.What is remedy? First make sure it's putting out enough water. There can be enough water coming out to get the carpet wet but not enough that it picks up much water. This is

...water runs out the the hose when I am done. It's used a lot, I shampoo all the carpets about 2 times a month and I shampoo the funiture 1 time a month. I bought it about 3 months ago. Hi, Here is a ...

...put it back in various selection and cant fix it please help ASAP liquid bladder will not release water. Hello, I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service ...

2 a tank of soap to 1 full tank of water. Also the spinning flow indicator works part time. Any suggestions where and what to look for? The valve at the bottom of the soap tank may have gone bad, Also

...water and I went through 2 bladders. We check the sucking action under the brissells and it was very weak. What should I be looking at to create better suction. Make sure you switch suction from hose ...

put the water in the bottom, where does the dirty water go? Can I get a manuel sent to me? 1. Release the handle and lay the machine handle back to access the tank. 2. Remove the tank from the base of

...2 water lines, dig out the clog, try to blow thru the heater to make sure it is open, then put back together. Otherwise it could be the belt, pump, seal not in place on the bottom of the tank or a ...

...put it back together. Push the water sprayer back on the end of the hose. Use the pliers to reposition the brass clip on the end of the hose over the water sprayer. Push the red water sprayer back ...

...put the soap in and where the water goes. 1. Step on the handle releae pedal and lay the handle back. 2. Remove the tank and take it to thesink. 3. Remove the top cover cover and fill the plastic ...