Question about Bissell Vacuums
...the brush of the bissell ProHeat i'm trying to install a new belt , but when i'm put back the brush it will com down, and the brush only when it is upright need to install belts need to install ...
...the belt to the brush. There is an idler pulley that takes up the slack in the V belt when you pull the handle back to vacuum. Make sure it is engaging properly and the V belt is installed
install brush bar dyson dc14 animal The brush won't spin on my dyson DC14 animal (purple one) I'm pretty sure the brush is installed correctly (I've cleaned and re-installed many times over the years)
Belt improperly installed. 4) Brush roll not spinning freely. (replace Brush Roll 5) Brush roll is not installed properly. 6) Machine is worn out where it pivots between the body and the lower nozzle.
...install new belt. Place new belt around brush. After pushing brush through the new belt, with belt loosely around brush slide brush back into housing 1 side at a time. The brush fits in very tightly. ...
...install the belt around the shaft and onto the brush before engaging the brush in it`s socket. Now use the brush to leverage into place.Check again for free smooth rotation, then replace the cover ...
...belt underneath of the brush roller, and it will not spin freely, and will burn immediately if the belt is pinched. It really can only be one of these two problems. I hope that this repair solution ...
...down, remove the bottom plate, remove the brush roll and belt, install new belt around motor shaft and brush roll, pull on brush roll to stretch belt far enough to drop brush roll back into
Question about Vacuums
...brush cover (3 screws, quarter turn to install or remove) and see if you have an earlier model or newer model. Earlier models are direct drive. One belt connects the motor to the brush. The newer ...
331 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions