Question about Shark Vacuums
can clean hair out of the bearings this way. Hair inside brush roller bearings can ruin a vacuum cleaner. The brush roller isn't meant to be taken apart so you should be sure of yourself when doing so
...roller assembly. The brushes are fairly well worn. Thanks, Arthur Summers The below site sells the rollers for some models. I'm not sure about yours. The second one, part number R-673273, may fit. ...
Question about Dyson Vacuums
apart and see no reason why it wont spin. Any ideas Hello, this is Ava with Think Crucial. There are a number of reasons why your brush roller has stopped moving. General maintenance to your vacuum is
Question about Shark Vacuums
...roller brush but unable to remove brush to clean. I've tried removing the tiny screws but they are next to impossible to remove? You have to remove All the screws, and you are correct they are almost ...
...roller doesn't spin i took nozzle apart , cleaned it out very well , tested it with just the hose, plenty of suction just same issue - brush roller isn't spinning . i've hit the reset button numerous ...
...apart My brushbar is not rotating Dyson V6 DC59 DC59 DC72 Motorhead DC62 or DC74 Fluffy Checking for... Hello, this is Ava with Think Crucial. There are a number of reasons why your brush roller has ...
...apart I realized that the spring that pushes the belt tight (to make roller spin) is not any where near strong enough to keep the brush rolling. My solution was to turn the belt inside out (there by ...
brush roll is really clogged with hair, the guy at Eureka just told me to use scissors (idiot) i cant get all the hair stuck on the sides of the roller with just scissors...can you help or do you have
Question about Dyson Vacuums
...roller, which is the one that takes all the beating and encounters all the dirt and grit is plastic welded into the clutch and cannot be replaced. You have to replace the entire clutch when that belt ...
apart again, spin the brush roller in your hand. Make sure it is free. When you reassemble it, before you refit the sole plate, turn the brush a few times with your fingers to make sure the belt finds
87 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions