Bissell 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum "remove bottom" Questions

...place can be removed. To remove the bottom plate Disconnect cleaner from outlet. Use a Phillips screwdriver to remove the 5 screws on the bottom plate. Lift off bottom plate. Hope this was

remove the bottom section. Do you know where I can find this info. I removed the separator and the 4 screws holding the bottom plastic section. Must I remove the nut under the separator to remove this

...is broken. It could be the broken belt wedged causing it to be difficult to remove the bottom cover. Make sure all the screws are removed and gently pry on the bottom cover with a small ...

remove bottom of cover on vacuum bottom. Making a How to remove bottom of cover on vacuum bottom. Making a loud noise so don't know what the problem is. Hoover Fusion Cyclonic Filtration System on ...

2 screws at the bottom of the vacuum. You will need to remove these 2 screws to be able to remove the bottom cover. Once the bottom cover is removed, you should be able to access the belt and agitator

...Remove the bottom plate screws & bottom plate. Remove the screws holding the motor and fan assembly to the nozzle housing. Remove the screws Holding the fan housing to the motor to gain access to ...

...Remove the top or bottom cover of the power nozzle/base of the vacuum. The screws will be on either the top or bottom of the base. Remove these screws to gain access to the brushroll. Remove the ...

...remove bottom plate, insert end of flat screwdriver into wide area of right-hand slot and push handle of screwdriver to the rear. Repeat in left-hand slot. 3. Lift extension of bottom plate, rotate ...

...remove the bottom plate and roller bar. Now you need to remove the belt from the motor pin lay on left side look t the round clip located next to the wheel which is holding the whole floor atachment ...

...remove bottom plate, insert end of flat screwdriver into wide area of right-hand slot and push handle of screwdriver to the rear.Repeat in left-hand slot. 3. Lift extension of bottom plate, rotate ...