brush. Remove the base plate. Remove the belt. Remove roller brush. Place new belt on roller brush and center it in position. Feed belt through the hole, and return brush to position. Ensure the brush
...remove the brush at the bottom of the machine.there are two screw in the red retainers at each side of the brush, remove the screws and the retainers and the pivot arms ,you should see the brush belt ...
...remove brush roll cover . 4) Remove brush roll and belt. Thread new belt around motor shaft and brush roll 5) Insert left end of brush roll first. Make sure square on brush roll cap is in place. Pull ...
...remove the brush by holding both ends and pulling straight out. Place the new belt on the brush wheel and replace the brush. With the belt on the brush wheel, stretch it to fit on the motor ...
...brush, remove the brush and the broken belt, and replace the belt, and put it back to gether. While you have the brush out, now would be a good time to clean it - remove the hair, etc from the brush ...
brush arms in place. Remove the two Phillips head screws to access the toothed brush belt. Check to ensure the belt is intact and looped around the brush end, as well as the red pulley with the ridges
...brush roll. Remove bottom plate and pull the brush roll out. Clean hair and debris from brush roll and make sure it spins freely. Remove end caps from brush roll if possible and clean debris out. ...
...brush. Remove the cover. Pull the roller brush out of the slots and remove it. The belt should be right there able to be removed. Replace the belt by placing it on the roller brush and then placing ...
remove the brush and old belt. clean the brush off really good and put it back with a new belt. This is normal maintenence for this model and should be done every 6 months. You can get the replacement
59 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions
