replace it. The beater bar is supposed to turn freely on its shaft and is held in place by an end cap on each end. These end caps just slide on the beater bar shaft. On my DC07 All Floor model I found
...end cap houses a 608ZZ ball brg. 3. Check each brg for freedom of smooth rotation. Replace both if either is seized. 4. Replace with either 608ZZ (dbl shielded) or 608 2RS (dbl sealed) brgs. 5. ...
...end caps on the brush bar which the brush bar actual spins in. These two caps are connected by a slim metal rod which runs through the brush bar. Place one hand on each side and begin to twist and ...
...end caps that will melt when the bearing heats up. This will cause the cap to go "off-centre" and the roller will vibrate badly. If this is the case, you will have to replace the roller. If the belt ...
...replace, but thanks to the YouTube video, I was able to get it in. HOWEVER this did not resolve the issue. I realized the beater bar was not spinning or was slipping. I thought I cleaned it all out ...
...replace, but thanks to this YouTube video, I was able to get it in: http://www.ezvacuum.com/dyson-dc07dc14-clutch-assembly-90025204-genuine-p-1636.html HOWEVER this did not resolve the issue. I ...
my roomba discover started running realy slow or barely moving when on carpet Replace your belt also check the end-caps on your beater bar to see of they are packed with fibers. clean out any you find
end caps and replace with exactly the same type. If you inspect the so called bearings, you may find matted up material that caused the stoppage. Clean and retry the system before getting a set of end
...end cap (it just slides on. You may have to rotate some). If the shaft comes out, that's okay. That just means the shaft came out of the opposite end cap. Clean out both ends and reassemble. Before ...
288 questions posted
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions